The Blue Main Spring is compatible with all Lincoln Infinity Series Automatic Traps, the SC-90E, and the Flying Rabbit. This is the highest spring tension option available for Lincoln Infinity Series Automatic Traps, and the medium spring tension option for the SC-90E and the Flying Rabbit. 

The Yellow Main Spring is compatible with all Lincoln Infinity Series Automatic Traps, the SC-90E, and the Flying Rabbit. This is the medium spring tension option available for Lincoln Infinity Series Automatic Traps, and the lightest spring tension option for the SC-90E and the Flying Rabbit. 

The Red Main Spring is compatible with the SC-90E and the Flying Rabbit manual traps. This is the highest spring tension option available.

This Spring is not compatible with any Lincoln Infinity Series Automatic Trap.

Restore any SC90E or Falcon throwing arm with this poly rail kit. Polyurethane breaks down and becomes hard over years of wear and weather. Fresh poly rails ensure consistent target flight. This kit includes two polyurethane strips and six roll pins. One kit supplies the parts needed to restore the rails on one arm. A 3/32” drill bit and punch are required for installation.

This kit is not compatible with Flying Rabbit arms.

SC154KIT Installation Instructions

Target stops degrade over years of use and exposure to weather. This kit includes two new rubber target stops with hardware for the SC-90E standard arm. Target stops provide a consistent location to place the target on the arm, target stops are critical to throwing a repeatable target.

These target stops are not compatible with rabbit arms.

This kit includes the parts required to replace the firing rod and associated hardware for the SC90E or FR9700.

The kit includes the following:

1 SC112 - Large Firing Rod Return Spring

1 SC112A - Small Firing Rod Return Spring

1 SC113 - Flat Washer

1 SC115 - Firing Rod Retaining Collar

1 SC147 - Plastic Wing Nut

1 SC114SA - Firing Rod Assembly

This assembly is found on the SC90E and Flying Rabbit traps. The Sear Bar assembly holds the arm in the cocked position, then pivots out of the way, allowing the trap to fire when the firing rod is pulled. Components of the sear bar assembly can become worn after years of use. A properly functioning sear bar assembly is essential to the operation of the SC90E or Flying Rabbit trap.